Oil changing is a necessary thing to keep your car’s engine in a well-running condition. If you are not changing your oil and oil filter then it may clog your engine with contaminations. We can understand that oil and oil filter changing is also money consuming process. That’s why we are going to discuss how to change the oil filter at home in easy steps.
But wait!
Let’s prepare for the procedure first. Definitely, we need some oil filter removal tools and things for oil filter replacement. So, here is the list of tools required for an oil filter change.
Tools require for oil filter replacement:
- New oil as per requirement and compatibility of your vehicle’s engine
- Oil filter best compatible with your car’s engine
- Metal ramps
- Spanners
- Old clothes and clean rags
- Oil draining pans or old bucket
Steps to change the oil filter at home:
- Lift up car’s front
- Remove cap and covers
- Drain old oil into oil draining pan
- Remove the old oil filter
- Replace the new oil filter
- Reattach the Sump plug
- Fill in new oil
1. Lift up car’s front:
First, start your engine and for a couple of minutes just to warm up the oil a little bit, not at full temperature. Warming up the engine is because warm oil is easy to drain than cold. While standing in your car you must apply a hand brake to avoid any kind of casualties. After this simply lift up your car with two ramps or a jack. This will help you to easily do all the procedures.
2. Remove cap and covers:
At the second step, now open the bonnet and remove all covers especially remove the oil cap. But first, carefully take out the dipstick. And get under the car where you have to remove plastic covers beneath the engine.
3. Drain old oil into oil draining pan:
Now, you have to drain out the old oil, so first put the sump oil right under the engine. Meanwhile, put the drain pan or old bucket under the sump plug. Furthermore, by using a spanner remove the sump plug and drain out the oil.
4. Remove the old oil filter:
At the next level, you have to take out the old oil filter. The oil filter is placed near the engine and it is about 4 inches long. Size can vary from company to company and according to the vehicle’s engine. While placing or removing oil filters you should consult your oil filter manual for better placement.
5. Replace the new oil filter:
At this level, you have to replace the new oil filter. Be careful while placing it, smear fresh oil on the rubber seal before fixing it. First, place the new oil filter and screw it properly with the engine block.
6. Reattach the Sump plug:
Be very cautious while placing a new oil filter in your car engine. You should know the demand and requirements of your car’s engine and the media of the oil filter. You can see our writing best oil filters for better assessment of compatibility and knowledge of oil filters.
7. Fill in new oil:
At last, clean the sump plug with a clean rag and make sure old oil drained out completely. Now, reattach all the covers and sump again and refill new engine oil compatible with your engine and filter.
In the end, start up the car’s engine and check the oil pressure light, make sure the warning light turns off in a while. If the light is on then you should check the oil filter because it may have leakage or any misplacement. On the other hand, if the light turns off then you must check the oil level by putting dipstick. Because the overflow of motor oil is also dangerous for oil filter and engine. So be careful when filling oil.
Wrap up:
In essence, changing the oil filter at home is much easier for the maintenance of the engine. One thing you should consider while changing the oil filter and engine oil is to be careful about technical things. If you don’t understand anything about the technicality then we suggest you avoid and don’t do it on your own. In short, we hope you will get everything about the question of how to change the oil filters at home.
Table of Contents